Nht iW1 Manuel d'utilisateur télécharger pdf (Page 4)

Packing List:

1 pair of baffles

1 pair of frames

1 pair of metal grilles

2 cutout template/paint shields

iWB mounting bracket includes:

(optional, purchased seperatly)

(1) Mounting bracket

(2) Mounting wings

(4) 5 x 50mm flathead screws

Tools Needed:

#2 Philips screwdriver

Pencil

Tape measure

Utility knife or keyhole saw

Level

Wire strippers

Safety goggles

Protective gloves

34567891011

12 12 13 14

iW1 iW2 iW3

Grille

Frame

Mounting Bracket

Mounting

Wing

iWB

(optional)

Baffles

Tech Tips: Pre-Wiring for New Construction

1. For best results, avoid running speaker wire near AC wire, as it may induce a 60Hz hum in the audio signal. It’s a good idea to run

the speaker wire after the AC wiring has already been completed, so that you can route the speaker wire at least three feet away from

the AC wiring. If speaker wire and AC wiring must run parallel, install the speaker wire within a steel conduit. Note that low voltage

wiring (doorbell, intercom, telephone, security, etc.) is unlikely to induce hum and can typically be run parallel to speaker cable with no

detrimental effects.

2. When drilling holes through wall studs or ceiling joists, use a drill bit that is at least as wide as the speaker cable that will be routed

through them. Always drill through the center of the stud or joist. If the hole must be drilled within one inch of the edge of a wall stud,

add a nail plate to the drywall side to protect the cable from possible nails and screws put in the wall later. Line up the holes in the

studs or joists as you go, so that pulling the cable through them will be easier.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Nht iW1 Manuel d'utilisateur Page 4